CAME VER KIT Manual do Utilizador descarregar pdf (Página 14)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

Photo 3.4 Photo 3.5

Take two of the angle pieces and place them as shown in

photo 3.4. Use nippers to cut off the portion of the top

angle piece from the left end to the fourth hole. Cut off

the portion of the bottom angle piece from the right end

to the fourth hole.

We will use the remaining long portions of the angle

pieces. They should appear as shown in photo 3.5.

Photo 3.6 Photo 3.7

Align the remaining two uncut angle pieces with the two

cut angle pieces, with the cut ends arranged as shown in

photo 3.6.

Use nippers to cut off the round protrusions indicated by

the dotted circles in photo 3.7. Removing these

protrusions will make it easier to secure the angle pieces

with screws.

Photo 3.8 Photo 3.9

In the places where you removed round protrusions, secure the angle pieces using nylon nuts and black screws. The

nylon nut should be on the inner side. Use radio pliers and a Phillips screwdriver to tighten the screws.

Note: The angle pieces will not be able to move if you tighten the screws too much. (Do not tighten the

screws all the way so that the angle pieces can turn, using the screw as a fulcrum.)

Outer side

of arm

Inner side

of arm

Outer side of arm

Top

Bottom

Cut the places indicated

by dotted lines with nippers.

This portion is not used.

Cut end

After cutting

This portion is not

used.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 91 92

Sem comentários

CAME VER KIT Manual do Utilizador Página 14