CAME VER KIT Manual do Utilizador descarregar pdf (Página 65)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

9. Power Supply Wiring

9.1. Preparing the Battery Snaps

In this section we will prepare the battery snaps and fashion power cables for the MCU board and

motor drive board power cables.

9.1.1. Fashioning Power Cables for Use with the RMC-RX62G Board

A wiring diagram of the power cable for the RMC-RX62G board is shown below:

MCU board

(RMC-RX62G)

22 mm red wire Toggle switch

–

55 mm red wire

65 mm red wire

Black wire

–

Heat-shrinkable tubing

Connector attached to RMC-RX62G board

XH Connector

Here we will fashion the MCU board power cable. Prepare the parts shown in photo 10.1.

 Toggle switch

 Electrical wire.

 Battery snaps (In addition, we will need heat-shrinkable tubing (dia. 10 mm).)

Use scissors to trim the sides of a battery snap as shown in photo 9.2.

Photo 9.3 Photo 9.4

Prepare a red and black electrical wire of 250mm. As shown in the photo, plug the red wire into the top

opening and the black wire into the bottom opening of

the connector.

250ｍｍ

Blac

Botto

Photo 9.1 Photo 9.2

Figure 9.1 (Wiring Diagram)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 91 92

Sem comentários

CAME VER KIT Manual do Utilizador Página 65