CAME VER KIT Manual do Utilizador descarregar pdf (Página 66)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

As shown in photo 9.5, slip the tip of a Stanley knife into the battery snap and open it as shown in photo 9.6.

Photo 9.5 Photo 9.6

Photo 9.7

Photo 9.8

Change the arrangement of the red and black wires

from that shown in photo 9.6 to that shown in photo

9.7.

Photo 9.9

Prepare all four battery snaps in the same way, so they

appear as shown in photo 9.9. The tasks described in

Fashioning the MCU Board Power Cable and

Fashioning the Motor Drive Board Power Cable each

require two of these battery snaps.

Photo 9.10

As shown in photo 9.10, cut the red electrical wire from the

MCU board into pieces 65 mm, 55 mm, and 22 mm long.

Make sure to measure the 22 mm piece of wire accurately

so that it will be positioned correctly relative to the battery

box. The lengths of the 65 mm and 55 mm pieces of wire

need only be accurate to within a few millimeters.

65 mm

55 mm

22 mm

Red

Touch the solder with a soldering iron to melt it and

remove the red and black wires.

Note: Save the wires removed from the battery snap

as they will be needed later on.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 91 92

Sem comentários

CAME VER KIT Manual do Utilizador Página 66