CAME VER KIT Manual do Utilizador descarregar pdf (Página 24)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

Photo 3.54

Once the top is flat, the task is finished.

3.5.4. Finishing the Front Shaft Support Plate and Motor Drive Board Support Plate

Photo 3.55 Photo 3.56

Trimming flat edges indicated by the lines in photo 3.55. so that the result likes photo 3.56.

Photo 3.57 Photo 3.58

The width of the rim of dotted line [2] of front shaft

support plate differs from dotted line [1]. Trim the rim of

dotted line [1] until the widths of [1] and [2] are same.

The width of the rim of dotted line [1] became same as

the dotted line [2]. Finally, round off four corners of

plate.

Front shaft

support plate

Motor drive board

support plate

[1]

[2]

Trim the rim of plate few mm.

Round off four corners of plate

Trimming

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 91 92

Sem comentários

CAME VER KIT Manual do Utilizador Página 24