CAME VER KIT Manual do Utilizador descarregar pdf (Página 88)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

10.6. Mounting the Motor Drive Board

10.6.1. Mounting Motor Drive Board, Ver. 5.1

Photo 10.65 Photo 10.66

For this task you will need four flat washers, four spring

washers, and four nuts.

Position the motor drive board as shown in the photo and

place a flat washer and a spring washer, in that order,

over the end of each of the studs in the locations

indicated by the circles.

Photo 10.67 Photo 10.68

Screw on and tighten the nuts in the four locations

indicated by the circles.

Connect the motor cables, taking care not to mix up the

left and right motor connections.

Black Red Yellow

Power cable

Servo motor

Photo 10.69

Connect the power cable of the motor drive board and the servo motor cable. Take care not to reverse the orientation

of the servo motor cable connector.

(For reference: Servo motor wires—black (–), red (+), yellow (signal))

Left moto

Left motor

Right motor

1 2 ... 83 84 85 86 87 88 89 90 91 92

Sem comentários

CAME VER KIT Manual do Utilizador Página 88